![]() #VCARVE VS ASPIRE TRIAL#carveco has a great number of tutorial videos to get you started. Vectric Aspire in 2022 by cost, reviews, features, integrations, deployment, target market, support options, trial offers, training options, years in business, region, and more using the chart below. Try searching for snapmaker 2.0 artcam postprocessor in the mean time! V-bit for finishing in the same pattern for this one, I’ll have to check my settings for the v-bit though. ![]() I used the 3.175mm flat end mill for clearing in a horizontal raster Since the snapmaker v-bit is much shorter than the clearing flat end mill i used, the tricky part was getting the height set after the bit change without any material left in the center of the project, but with some careful measurement and noting the machine work origin it is not too bad. ![]() The key is using one of these programs that allows exporting at least two separate toolpaths (one for roughing and clearing, one for the fine detail.) Vcarve looks good, as Markus recommended, but for my needs at the moment, I wanted to test this out and carveco fit the bill at their cheap subscription instead of spending a few hundred outright. Click the buttons below to view more about specific features Machine Parts on Two Sides Adds the ability to create double-sided projects in the same session. I entered my own tool settings though for this one, and I’m actually a bit happier with the results than the other database for the v-bit. Aspire lets you dynamically edit 3D components using the mouse as well as giving you the ability to enter specific values to manipulate the part. ![]() There is a thread on here somewhere with the tool database and the post processor. Fusion 360 is good, but a bit complicated and too expensive after the free year they give you.Īs Carveco used to be artcam, it has a good established base and the artcam post processor works. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |